NDLI: Author index

Please wait, while we are loading the content...

2013 IEEE Symposium on Industrial Electronics & Applications

2012 IEEE Symposium on Industrial Electronics and Applications

2011 IEEE Symposium on Industrial Electronics and Applications

Welcome message

Organizing committee

International advisory/liason

Technical program overview

Technical program

Robust decoupling current control to magnetic saturation for SynRM using flux observer

1.575 GHz to 2.48 GHz multi-standard low noise amplifier using 0.18-µm CMOS with on-chip matching

Design of UWB LNA with interference rejection using coupled inductors

Ultra-low power Digital System Design using Sub-threshold logic styles

Prediction of interface conductivity of cement slurry during early hydration considering the effect of curing temperature and pressure

A 0.13µm inductively degenerated cascode CMOS LNA at 2.14GHz

A CMOS retinal rotational sensor for clockwise/counterclockwise detecting and velocity measuring

Bypassing the short-circuit faults in the switch-ladder multi-level inverter

Identification of DC motor drive system model using Radial Basis Function (RBF) Neural Network

Simulation of grid connected THIPWM-three-phase inverter using SIMULINK

DC power supply based on single-phase matrix converter with reduced number of switches

Simulation of Cascaded H-Bridge Multilevel Inverter for liquid food sterilization with various distance of the electrodes gap

A comparative study of Proportional Integral Derivative controller and Fuzzy Logic controller on DC/DC Buck-Boost Converter

A novel method of implementing real-time buck boost converter with improved transient response for low power applications

Controlling and modeling power-electronic interface DERs in islanding mode operation micro grid

Comparison between transformer-based Vs. transformer-less UPS systems

Passive damping network for a Single Phase Matrix Converter (SPMC) operating as a rectifier

Minimum power loss for high-side power MOSFETs in DC-DC converter with TBO and high cell density

Fuzzy Logic Controller for MPPT SEPIC converter and PV single-phase inverter

Multi-output ZCS-SR inverter fed voltage multiplier based high voltage DC-DC converter

Suggesting a DC-DC Buck converter for compensating shaft induced voltage and bearing current

Energy level performance of error control schemes in WSN over Rayleigh fading channel

Investigation of indoor Wireless-N radio frequency signal strength

Synthesis of linear array antenna with uniform side lobe level and fixed dynamic range ratio using iterative fast Fourier transform

Outage and energy level performance of layered CDMA wireless sensor networks with space diversity

Implementation of the Advanced Encryption Standard on GPUs with the NVIDIA CUDA framework

Spectral efficiency of unipolar SAC-OCDMA system considering noise effects

Third order intermodulation distortion effect on the constellation error in RF transmitter of IEEE 802.11a WLAN system

Hybrid OCDMA/WDM system using complementary detection technique for FTTH access networks

Craziness Particle Swarm Optimization based synthesis of Concentric Circular Antenna Array with non-isotropic elements

Performance analysis of transparent and non-transparent relays in MMR WiMAX networks

Simulink/ModelSim co-simulation of sensorless PMSM speed controller

Extending wireless sensor network lifetime with base station repositioning

Minimization of side lobe level and side band radiation of a uniformly excited time modulated linear antenna array by using Artificial Bee Colony algorithm

Voltage-mode SIMO OTA-C universal filter

Asynchronous to synchronous: A design methodology

Multiple polynomial regression for modeling a MOSFET in saturation to validate the Early voltage

Cone extraction technique for incremental static timing analysis

A methodology for automation structured datapath placement In VLSI design

Composite video transmission as current overlay using the powerline concept of FAMPLC in the Remotely Operated Vehicle

CAD automation module based on cell moving algorithm for ECO timing optimization

An improved interconnect noise methodology for reduced pessimism using dAP model

A digitally programmable folded cascode OTA with variable load applications

Robust speed control of a PMSM through sliding mode controller design

A CMOS retinal computational sensor for 2-D image tracking and velocity measuring

Performance analysis of a power line communication system over a non-white additive Gaussian noise channel

Relationship between acoustic emission signal strength and damage evaluation of reinforced concrete structure: Case studies

Linear phase FIR high pass filter design using PSO-CFIWA with least square approach

A scaled experiment for verificaton of SPLINE interpolation technique for sea bed logging method

Optimization of linear phase FIR band pass filter using Particle Swarm Optimization with Constriction Factor and Inertia Weight Approach

A modified structural method for shape recognition

Damage severity evaluation on reinforced concrete beam by means of acoustic emission signal and intensity analysis

Navigation and surveillance using night vision and image fusion

Time-frequency based signal restoration for Laser-Ultrasound signals with applications in Nondestructive testing

Two-class classifier cellular automata

A decomposition procedure to linearize the non-affine state space average model of STATCOM

Subjective assessment of 3D visual sensation and preference

Dynamic path planning algorithm in mobile robot navigation

Feedback control schemes for gantry crane system incorporating payload

Design and analysis of wireless controller panel using RF module's for robotic wheelchair

Experimental evaluation of Active Vibration Control of a flexible plate using proportional gain controller

TriBot: Dragging locomotion three-finger robot

Neural network based model reference adaptive control (NMRAC) for steam temperature regulation in steam distillation process

Advanced container transportation equipment using transfer robot and alignment system

An investigation of color based marker recognition for 3D instrument localization in surgical applications

3WD omni-wheeled mobile robot using ARM processor for line following application

Protection unit design and simulation for synchronous generator based FPGA technology

Transmission loss minimization using SVC based on Particle Swarm Optimization

An intelligent actuator controller for wireless sensor/actuator networks

Scalable storage architecture in modular hardware accelerators

Effect of nitrogen doping on electrical properties of amorphous carbon thin film prepared by aerosol-assisted thermal CVD

Optical characterization of different LED packages at various biasing current

Effect of the precursor solution concentration of Copper (I) Iodide (CuI) thin film deposited by mister atomizer method

Scalable host controller for modular hardware accelerator

Effect of thickness on the electrical and optical properties of MEH-PPV:TiO2 nanocomposite for organic solar cell application

An automated clock distribution topology in SoC designs

Effect of deposition time SnO2 thin film deposited using thermal CVD for humidity sensor application

Characteristics of Aligned Aluminum-Doped Zinc oxide nanorod arrays via a novel sonicated sol-gel immersion

Molar concentration effect on MgO thin films properties

Realization of an FPGA-based Motion control system for electric standing wheelchairs

Design, simulation and fabrication of a fuel efficient urban class series hybrid vehicle

Optimization of Tesla turbine using Computational Fluid Dynamics approach

Behaviour of grid connected photovoltaic systems

An iterative method for designing high reliable standalone PV systems at minimum cost for Malaysia

The numerical estimation method of series FACTS compensator based on injection model of voltage source inverter

A very fast power factor calculation method

Development of intellectual property for Brushless DC Motor drives

Sizing grid-connected photovoltaic system using genetic algorithm

Implementation of a internet-based power quality monitoring system by dual microprocessors

Integration of pitch regulated fixed speed wind turbine in a radial distribution system

Transient stability analysis on Sarawak's Grid using Power System Simulator for Engineering (PSS/E)

Input-input relationship constraints in T-way testing

Shape-based matching: Defect inspection of glue process in vision system

Developing land use scenario dynamics using Cellular Automata and agent integrated model

Computational fluid dynamics analysis of shelland-double concentric-tube heat exchanger

Developing E-market model using social networks

Multi-user navigation: A 3D mobile device interactive support

Comparison of metahuristic test generation strategies based on interaction elements coverage criterion

Effects of traffic speed level on frustration index in cellular automata traffic simulation

Interaction test data generation using Harmony Search Algorithm

The implementation of crossover factor, fTIG in the Finite Persisting Sphere Genetic Algorithm

An Example-Based Machine Translation approach for Bahasa Indonesia to English: An experiment using MOSES

Attitudes toward dysfunctional audit behaviour: The effect of budget emphasis, leadership behaviour, and effectiveness of audit review

Development of rubber tire gantry crane (prototype) obstacles avoidance method using a single sensor on microcontroller based

Comparative analysis of simplified and standard fuzzy logic controller in vector controlled PMSM drive

CMOS image sensor binning circuit for low-light imaging

Side-coupled single-mode ring resonator with transmission zeros

A novel approach of feeding, impedance matching and frequency tuning of microstrip patch antenna by single microstrip line

Circuit diagram of a single-mode microwave ring resonator

Internal ringing effect in capacitive micromachined Ultrasonic Transducer

Thermal measurements of two layered thin films of different orders on copper

GaInNAs QW with GaNAs intermediate layer for long wavelength laser

Safe operating condition and lifetime estimation in p-MOSFET device due to Negative Bias Temperature Instability

Paper study on thermal conductivity of Al2O3 thin film of different thicknesses on copper substrate under different contact pressures

Integration of Scalar Control in Space Vector Pulse-Width Modulation for robust motion controller

Prototype of channel coding algorithms for digital signal processing board

Design and implementation of fuzzy based controller for modern elevator group

Surgical and non-surgical prosthetic hands control: A review

The importance of the very low frequency power of heart rate variability in screening of patients with obstructive sleep Apnea

Screening of bone marrow slide images for Leukemia using Multilayer Perceptron (MLP)

Study on the stability of nanodrugs using particulate growth technique

Characterizing autistic disorder based on Principle Component Analysis

Development of PI controller for disc speed

Contextual classification of Cropcam UAV high resolution images using frequency-based approach for land use/land cover mapping case study: Penang Island

The effect of anomaly detection accuracy in varying the angular resolution of sonar using Repetitive Observation Strategy

Design and development of electrical powered wheelchair model for navigation control

Z-source inverter with improved performance for photovoltaic applications

Design of long range MIMO Wireless Data Acquisition System

Efficient test environment for multi-level simulations of mixed-signal systems on chip

An automatic biomedical acquisition system for hospital registration

Outsource bond pad reliability methodology setup for foundry process changes

Sensorless control of non-salient pmsm using asymmetric alternating carrier injection

Design and development of MY $2^{nd}$ EYE for visually impaired person

Towards smart wireless sensor actor networks: Design factors and applications

Minimizing torque ripple and copper losses in variable speed brushless DC motor

XILINX FPGA design for Sinusoidal Pulse Width Modulation (SPWM) control of Single-phase Matrix Converter

State-space approach controller design for PLC-based PWM-driven variable speed drive

A CMOS LED print head driver with compensation circuits

Voltage-mode MISO OTA-C biquad filter

Analysis of configuration bit criticality in designs implemented with SRAM-based FPGAs

Design and implementation of BPSK transmitter and receiver for Software Defined Radio on a Model Based Development Platform

Assessment of non-destructive test and hypothesis techniques in monitoring lubricant's condition

2010 IEEE Symposium on Industrial Electronics and Applications (ISIEA)

2009 IEEE Symposium on Industrial Electronics & Applications

Central Library (ISO-9001:2015 Certified)
Indian Institute of Technology Kharagpur
Kharagpur, West Bengal, India | PIN - 721302

See location in the Map
03222 282435
Mail: support@ndl.gov.in

Sl.	Authority	Responsibilities	Communication Details
1	Ministry of Education (GoI), Department of Higher Education	Sanctioning Authority	https://www.education.gov.in/ict-initiatives
2	Indian Institute of Technology Kharagpur	Host Institute of the Project: The host institute of the project is responsible for providing infrastructure support and hosting the project	https://www.iitkgp.ac.in
3	National Digital Library of India Office, Indian Institute of Technology Kharagpur	The administrative and infrastructural headquarters of the project	Dr. B. Sutradhar bsutra@ndl.gov.in
4	Project PI / Joint PI	Principal Investigator and Joint Principal Investigators of the project	Dr. B. Sutradhar bsutra@ndl.gov.in Prof. Saswat Chakrabarti will be added soon
5	Website/Portal (Helpdesk)	Queries regarding NDLI and its services	support@ndl.gov.in
6	Contents and Copyright Issues	Queries related to content curation and copyright issues	content@ndl.gov.in
7	National Digital Library of India Club (NDLI Club)	Queries related to NDLI Club formation, support, user awareness program, seminar/symposium, collaboration, social media, promotion, and outreach	clubsupport@ndl.gov.in
8	Digital Preservation Centre (DPC)	Assistance with digitizing and archiving copyright-free printed books	dpc@ndl.gov.in
9	IDR Setup or Support	Queries related to establishment and support of Institutional Digital Repository (IDR) and IDR workshops	idr@ndl.gov.in