NDLI: Analysis of radial force for switched reluctance motor

Please wait, while we are loading the content...

2013 IEEE International Conference on Applied Superconductivity and Electromagnetic Devices

Design and experiment of a bridge-type chopper for low-voltage SMES application

A digital prediction control method for high-precision energy charge and discharge of superconducting magnet

A platform for PMLSM using field oriented control and SVPWM based on virtual instrument

Experiment of a MOSFETs-based bridge type fault current limiter prototype

Risk assessment of power grid catastrophic accident based on AHP and fuzzy simulation

Application of sensor technique in transformer fault diagnosis

An improved three-level inverter SVPWM control method

Battery charge-discharge control strategy based on the single Z-source three-level SVPWM inverter

A study on the effect of water conductivity in the underwater active electrolocation

Simulation model of a MOSFETs-based bridge type superconducting fault current limiter prototype

A novel particle trap in compressed air insulated transmission line

Performance of overvoltage transducer for overhead transmission lines

Harmonic elimination in multiple synchronous rotating reference frames of PMSG for wind power generation

Tunneling spectroscopy of the Superconductor-Insulator Transition on Bi2Sr2Ca1−xYxCu2O8+δ and (Bi1−yPby)2Sr2Ca1−xYxCu2O8+δ

Phase lead correction for VSI single-loop control

Study on the impulse characteristics of capacitive voltage transformer

Improvement on the corona model of ultra high voltage alternating current transmission lines

Experimental study on the controlled discharge characteristics of a liquid nitrogen cooled HTS coil

Modeling and energy exchange characteristic analyses of a simplified DC SMES system

Coordination protection of low-voltage AC distribution network in vessel DC Zonal Electrical Distribution System

System Protection for vessel DC Zonal Electrical System supplied by Medium Voltage DC

B-H relations of magnetorheological fluid under 2-D rotating magnetic field excitation

Influence of second milling time on temperature dependence of low loss MnZn power ferrites

Medium-frequency-link power conversion for high power density renewable energy systems

The design of the modules of W-band power allocation

A novel compact Ka-band threeway power splitter/combiner

Determination of design parameters for a short-axis 10 MW HTS wind generator

Numerical simulation on temperature and stress of pulsed laser repairing fused silica defects

A 92–96 GHz high isolated power divider using modified hybrid coupler structure

A novel calorimetric method for measurement of AC losses of HTS tapes by optical fiber Bragg grating

A broadband pulse detector for K- and Ka-band

Research and design of the millimeter wave power equalizer using waveguide on Ka-band

A modified Z-source inverter control system based on TMS320LF2812 DSP

Design of a wideband low noise amplifier

Design of a W-band MMIC balanced BPSK modulator

A novel microstrip UWB bandpass filter using stub-loaded multiple-mode resonator

Design of UWB bandpass filter using highpass and dual-plane EBG lowpass filters

Dual-notched UWB antenna using dual-mode resonator

UWB BPF using SCRLH transmission line structure

K-Ka band schottky diode limiter

Design of lowpass filter with ultra-wide stopband and high selectivity based on DGS resonators

A novel W-band waveguide-to-microstrip antipodal finline transition

The nuclear magnetic resonance probe based on a printed circuit board planar microcoil

The miniaturization of high-power time-domain antenna

A study on HTS double pancake coil for electric machine

Simulation analysis of a synchronous generator system under fault conditions

Inland river ship supervision system based on ZigBee and RFID technology

Notice of Violation of IEEE Publication PrinciplesStudy of fault-tolerant routing algorithm of NoC based on 2D-Mesh topology

Research of online detection of routing transmission errors of NoC

Characteristics of HTS linear generator in the sinusoidal driving mode

LabVIEW-based multi-channel measurement and protection system for HTS device applications

Enhancement of LVRT performance and alleviation of power fluctuation of DFIG wind turbine in DC microgrid by SMES

A high-temperature superconducting step-edge Josephson junction mixer

Current-fed quasi-Z-source inverter-based adjustable speed drive system(ASDs)

An intelligent communication scheme for power protection system

Failure analysis of IGBT in intelligent power module

Study on passive filter in wind power converter

Study on heat dissipation performance of IGBT module in wind power converter

Advanced metering key technologies of supporting the implementation of step electricity tariff

High voltage insulation test for high Tc superconducting types

The performance of a power system high Tc superconducting fault current limiter with saturable core under symmetrical fault conditions

Optimal allocation of superconducting fault current limiter using multi-objective estimation of distribution algorithm based on bacterial foraging

Plenary talk — Applied HTS research and practical applications in Europe

Plenary talk — Development of superconductor materials for applications

Plenary talk — Practical HTS FCL development — Updates of Innopower's SFCL R&D projects

Plenary talk — European project and application of high Tc superconducting cable

Plenary talk Ȕ Progress in production and performance of second generation (2G) HTS wires and practical applications

Plenary talk — Second generation HTS wires and applications — AMSC wire updated

Plenary talk — Bi-2223 wire and its future in large scale application

Plenary talk — Superconducting magnetic resonance imaging technology

Plenary talk — Development of high field magnet technology and applications

Plenary talk — HTS superconducting wire development and applications in Korea

Plenary talk — Development of innovative electrochemical energy and conversion devices

Keynote talk — HTS SMES device technology and application

Plenary talk — Progress towards superconducting magnets using high temperature superconductors: An integrated approach

Plenary talk — Developments of HTS microwave passive and active devices and their applications in space and on ground

Plenary talk — The evolution of power electronic converters for electric drive systems

Keynote talk — Recent development for cost-effective secondary-generation HTS tapes

Small dual-band-notched antenna design by integrating with two resonators

Design of a band-notched UWB antenna based on EBG structure

Design and simulation of an UWB single-ridge waveguide band-pass filter

Compact 10 dB broadband directional coupler

Novel maximum power point tracking strategy for photovoltaic system under partially shaded condition based Monte Carlo algorithm

Improved high performance control strategy for micro grid islanded operation

Novel decoupling model predictive current control strategy for flux-switching permanent magnet synchronous machines with low torque ripple and switching loss

Single and dual-band terahertz metamaterial

Terahertz filter based on a composite metal-dielectric-metal structure

Analysis and design of a new conformal slot antenna for proximity fuze

A band-notched UWB antenna with L-shaped slots and open-loop resonator

Design process and performance analysis of a short-axis 10 MW HTS wind generator

Five ports ridge waveguide power divider with compact size

AmpaCity — Installation of advanced superconducting 10 kV system in city center replaces conventional 110 kV cables

Research of icing thickness on transmission lines based on fuzzy Markov chain prediction

Fuzzy logic controlled SMES system

A unidirectional bullet conformal monopole antenna designed for impulse radar system

Explosive percolation with cluster aggregation model

Exact analytical method for magnetic field computation in the concentric magnetic gear with Halbach permanent-magnet arrays

Parameter identification of transformer insulation based on frequency domain spectrum method

Reradiation interference resonance on wireless station from UHV power lines

Protecting distance calculation of reradiation interference on AM broadcasting station from UHVDC power line

Novel flux-regulatable dual-magnet vernier memory motors for electric vehicle propulsion

Analysis of temperature rise in reactors using coupled multi-physics simulations

Simulation of SVPWM overmodulation algorithm in 60° coordinate system

A test method for delay faults in NoC interconnects

A research on the parameter of high magnetic field discharge circuit

LabVIEW-based intelligent platform for HTS measurements

Simulation analysis and application of the fast electromagnetic repulsion device

Optimum design of ampere-turn balance for power transformer

Investigation of AC losses for HTS coils with parallel wound copper tapes

Dynamic deformation analysis of power transformer windings by considering the effect of elasticity characteristics of kraft paper

Research on electromagnetic guided wave signal noise reduction technology based on lifting wavelet transform

Analysis of reactance-type superconducting fault current limiter to the transient stability of power system with two machine system

Study of gradient of raise edge of discharge current in RLC electric circuit

A novel magnetic method for active underground cable localization using three-component sensors

Design and simulation of a magnetic flux-to-field transformer for GMI/superconducting mixed magnetometer application

Analysis of radial force for switched reluctance motor

Different short-circuit impedance calculation method of controllable reactor of transformer type

Analysis of two kinds of integrated magnetic structure of controllable reactor of transformer type

Simulation of switching overvoltage of step-up transformers in wind farms

Discussion about Maxwell equation based on monopole

Simulation and test of a linear induction coil launcher prototype

Research on topology and modulation of multilevel inverter

A novel target field approach to design of biplanar gradient coils for permanent MRI system

Rotational core loss features of soft magnetic composite materials under excitation frequencies from 5 Hz to 1000 Hz

Three-Dimensional vector Preisach hysteresis model of the soft magnetic composite material

Study of the rotor screen for a 12 MW superconducting direct-drive wind generator

The research of thickness measurement to thin materials by ultrasonic amplitude spectra

Multi-objective optimal design of rectangular symmetric double-ridge waveguide

Study on the return loss characteristics of rectangular single ridge waveguide slot

Lapping dielectric design of 110 kV HTS cable body

AC dielectric strength of polymer materials under tensile stress at 77K and normal temperature

The effect of coupling current and equivalent electrical length in terahertz modulator

UWB band-notched monopole antenna design using left-handed materials

Development of magnet technology and applications

Investigation of orthogonal experiment for fabrication of soldering joint for a 4 T HTS coil

Study on field suppression unit in DC excitation system for saturated iron-core superconducting fault current limiter

Development of a 400 m YBCO racetrack coil for HTS machine applications

A compound control system for a PMLSM based on virtual instrument and digital signal processor

Design, fabrication, and operation of the cryogenic system for a 220kV/300MVA saturated iron-core superconducting fault current limiter

Prospect for application of superconducting fault current limiter in Chinese power grid

Application prospects of integrated SMES technology for future smart grids

Characterization of Josephson tunneling junction by lifetime of zero-voltage state and fiske self-resonant step

Study on the simplified distributed parameter model for HTS power cables

Superconducting magnet of magnetic resonance imaging system

Keynote talk — Review of AC loss measuring methods for HTS tape and unit

Keynote talk — Cryogenic cooling techniques and coolers for HTS power applications

Keynote talk — Design of large electrical machines

Keynote talk — Superconducting magnets for MRI applications

Keynote talk — Manufacture and test of large size Bi-2223 HTS magnet coil

Current status of demonstration and comercialization of HTS cable system in grid in Korea

Fault analysis of HTS power transmission cables

Cost-effective and high-rate process for solution-drived YBa2Cu3O7-δ coated conductors

Review of AC loss measuring methods for HTS tape and unit

Progress in production and performance of second generation (2G) HTS wire for practical applications

2011 International Conference on Applied Superconductivity and Electromagnetic Devices

2009 International Conference on Applied Superconductivity and Electromagnetic Devices

Analysis of radial force for switched reluctance motor

Content Provider	IEEE Xplore Digital Library
Author	Hai Jun Zhang Chuang Gao Shu Hong Wang
Copyright Year	2013
Description	Author affiliation: Fac. of Electr. Eng., Xi'an Jiaotong Univ., Xi'an, China (Hai Jun Zhang; Chuang Gao; Shu Hong Wang)
Abstract	Radial force acting on the salient stator poles is the main source of electromagnetic vibration and acoustic noise for switched reluctance motor. In this paper, an analytical mathematical model is presented for the investigations of radial force characteristics and influence factors such as phase current, air gap length, rotor position and other structure parameter. The two-dimension finite element (2-D FE) was used to calculate the radial force and compared with the analytical model. Results show that the radial force calculated from analytical model can be well coincident with the data obtained by finite element method which is helpful for studding the design and control strategies for the vibration reduction.
Sponsorship	IEEE Beijing Sect.
Starting Page	418
Ending Page	419
File Size	244481
Page Count	2
File Format	PDF
e-ISBN	9781479900701
DOI	10.1109/ASEMD.2013.6780809
Language	English
Publisher	Institute of Electrical and Electronics Engineers, Inc. (IEEE)
Publisher Date	2013-10-25
Publisher Place	China
Access Restriction	Subscribed
Rights Holder	Institute of Electrical and Electronics Engineers, Inc. (IEEE)
Subject Keyword	Vibrations Analytical model Analytical models Switched reluctance motor Force Rotors Stators Radial force Reluctance motors Finite element
Content Type	Text
Resource Type	Article

Central Library (ISO-9001:2015 Certified)
Indian Institute of Technology Kharagpur
Kharagpur, West Bengal, India | PIN - 721302

See location in the Map
03222 282435
Mail: support@ndl.gov.in

Sl.	Authority	Responsibilities	Communication Details
1	Ministry of Education (GoI), Department of Higher Education	Sanctioning Authority	https://www.education.gov.in/ict-initiatives
2	Indian Institute of Technology Kharagpur	Host Institute of the Project: The host institute of the project is responsible for providing infrastructure support and hosting the project	https://www.iitkgp.ac.in
3	National Digital Library of India Office, Indian Institute of Technology Kharagpur	The administrative and infrastructural headquarters of the project	Dr. B. Sutradhar bsutra@ndl.gov.in
4	Project PI / Joint PI	Principal Investigator and Joint Principal Investigators of the project	Dr. B. Sutradhar bsutra@ndl.gov.in Prof. Saswat Chakrabarti will be added soon
5	Website/Portal (Helpdesk)	Queries regarding NDLI and its services	support@ndl.gov.in
6	Contents and Copyright Issues	Queries related to content curation and copyright issues	content@ndl.gov.in
7	National Digital Library of India Club (NDLI Club)	Queries related to NDLI Club formation, support, user awareness program, seminar/symposium, collaboration, social media, promotion, and outreach	clubsupport@ndl.gov.in
8	Digital Preservation Centre (DPC)	Assistance with digitizing and archiving copyright-free printed books	dpc@ndl.gov.in
9	IDR Setup or Support	Queries related to establishment and support of Institutional Digital Repository (IDR) and IDR workshops	idr@ndl.gov.in