NDLI: Calculation features of the ultrasonic vibrating systems

Please wait, while we are loading the content...

2015 16th International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices

2014 15th International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices (EDM)

2013 14th International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices

Table of contents

Section I: Semiconductor physics and technology [breaker page]

Monte-Carlo modeling of Langmuir evaporation of GaAs (111) substrates

Molecular beam epitaxy of solid solutions GaPxAs1−x: Effect of growth condition on the composition of group V sublattice

Stochastic resonance in VO2 thin films

Modeling of misft dislocation creation at Ge island — Si(111) substrate interface

Influence of temperature and catalyst drop diameter on GaAs nanowire growth

Numerical model for MIS-structures characterization

Flow-through ordered macroporous silicon sensor for liquids detection

GaAs MBE on vicinal substrates Si(001): Impact of nucleation and growth conditions on surface morphology and crystallographic properties of the epitaxial layers

Thermal modeling of pulse current trimming

Shape of epitaxial Ge islands on Si(100) surfaces

The modification of Mn-Zn-ferrite surface by a low-energy electron beam

Structural properties of silicon oxide prepared by high-power PECVD

Monte Carlo simulation of GaAs nanostructure growth by droplet epitaxy

Abnormal electrical capacitance behavior of VO2-films-based microstructures near semiconductor-to-metal phase transition

The investigation of Pt/HgCdTe and oxide/HgCdTe heterointerface formation by method XPS in situ

Section II: Radio- and telecommunications. Microwave technology [breaker page]

Adaptive thresholding for contrast detection of objects of indefinite form

Gain power radio signal in a resonant microwave compressor with the transformation of vibration modes

Simulation of probability-time characteristics of wireless MAC protocols WiMAX-like with fixed super frame formats

Robust detection algorithm for future 4G wireless communication systems

Development of low-power device for wireless data transmission under the 6LoWPAN standard

Virtual devices technology for UHF

Efficiency estimation of Call-center's productivity

Method of communication in optical networks

Forecast modeling of longevity of objects

Measurement systems for the analysis of distortions caused by the passage band signals through nonlinear devices

Modeling and application of microwave detector diodes

The uniform method of calculating the electro-optic characteristics of broadband integrated optical intensity modulator

Section III: Sonic and ultrasonic devices: Physics, electronics, application [breaker page]

Parameter monitoring of ultrasonic apparatuses at the application of different working tools

Development of the equipment for ultrasonic treatment of biological tissues with simultaneous spraying of medicines

Study of the process of liquid atomization from the ultrasonic disk radiator

Studies of functional possibilities of model sample of the ultrasonic apparatus for drilling of the simulator of lunar soil

Modes and conditions of efficient ultrasonic influence on high-viscosity media in the technological volumes

The operation features of the disk radiators in gaseous media at high temperature

Conveyor machine for ultrasonic welding of the wares made of thermoplastic materials

Calculation features of the ultrasonic vibrating systems

The construction development of the resonance concentrating link with enlarged radiating surface

Rules and features of the design of piezoelectric sources of high-intensity ultrasonic action

Ultrasonic dimensional processing of hard and brittle materials (graphite articles)

Development of the construction of the apparatus for centrifugal acoustic collection of nanoscale aerosols

The control of the ultrasonic coagulation of dispersed nanoscale particles

The development of the agglomerator for efficiency increase of the separation of nanoscale particles

Deburring of small parts in hard-to-reach places by ultrasonic action

Perfecting of the technology and development of the apparatuses for ultrasonic welding

Ultrasonic drier of list materials

Effect of ultrasonic treatment on conductivity and pH indicator solutions of organic acids

Section IV: Optoelectronic devices and systems: Physics, electronics, application [breaker page]

Research of dynamic characteristics of the artificial sources of optical interference

Angular and energy characteristics of luminescence of solutions of dye R6G with nanoparticles of aluminum

High stability clock generator based on fiber optics

Laboratory sample of multipoint system to determine the arrangement of the explosion source

Determining of the explosion source arrangement by multipoint electro-optical system based on the method of the gravity center

Laboratory sample of high-speed multithreshold control gauge of the emergency and preemergencies in an explosive atmosphere

The effect of treatment in highly-ionized medium on the structural and optical properties of proton exchanged planar waveguides in LiNbO3

Development of automatic brightness control system model for image intensifier

Formation and automatic calculation of the dynamic time parallax in binocular vision system

Laboratory pattern of position pyrometric detector of explosion with field stop

Effect of proton exchange waveguide on domain kinetics of lithium niobate

Laboratory research of the ignition center coordinates pyrometric gauge with cylindrical lenses

Investigation of the three-channel optical system with separated lenses of the channels

Experimental research backscattering in the disperse system

Automated control system of experimental unit for exercise of dust-gas-air mixture explosions

Section V: Power electronics, mechatronics and automation [breaker page]

Z-source inverter with neutral point

AC-AC converter based on six-phase active rectifier and current source inverter

Scalar modulation control technique for modular multilevel matrix converter

Novel structure of variable speed drive for ESP induction motor control

Speed control of sensorless induction motor drive based on model predictive control

Review of AC voltage generation systems based on multilevel converters and photovoltaic cells

The ADC implementation for high-frequency converter of the electrical energy

LED driver based on zero-voltage-switching buck converter with on-time control

Diesel-generator set working in parallel with electrical energy storage system

Analysis of output characteristics of three-phase voltage source inverter with new hysteresis control algorithms

Cluster approach in education: Development of educational laboratory board for microprocessor technologies with using of Intel 80386EX JTAG unit

The development of the direct electric drive system of a radar station antenna

Design of a teaching-research laboratory breadboard for studying of the multilevel voltage inverter with switched capacitors

Analysis of coupled inductors in AC variable frequency generation system

A three-phase zero-current-transition and quasi-zero-voltage-transition inverter/rectifier with reduced stresses on devices and components

Principles of electric power generation based on the self-excited electrical machines using the perspectives of the automatic control theory

Three-phase three-level voltage source inverter construction based on quasi-Z-source cells

Development of phoniatrist's workplace

Permanent magnet machine control of starter-generator

Simulation of power electronic devices using OrCAD software tool

AC electronic motors application possibilities in vehicles

Cycle-converter based on six-phase zero circuit with high input power factor

DC-bus voltage control strategy of active power filter

UAV airplane control system design via time-scale separation technique

UAV control scheme for trajectory realization under non-zero wind conditions

Transistor converters as a part of four-wire autonomous power generation system

Solar array regulator based on buck converter with sequential switched sections

AC voltage regulator on the basis of the consecutive voltage regulator with PWM

Digital control system with system of automatic control for three-phase two-zone thyristor AC voltage regulator

New family of AC regulators with the switched quasi-impedance of power supply or load

State observer for sensorless vector control of doubly fed induction motor

The structure of the hybrid control system for voltage source inverter in the autonomous power generation system

Electric starter mode of synchronous generator with permanent magnets

Optimization of resonant tank parameters of zero-current-switch boost converter

Comparative analysis of prospective high-voltage direct current converters of electric locomotive

International Conference and Seminar of Young Specialists on Micro/Nanotechnologies and Electron Devices

2011 International Conference and Seminar on Micro/Nanotechnologies and Electron Devices Proceedings

2010 11th International Conference and Seminar on Micro/Nanotechnologies and Electron Devices

2008 9th International Workshop and Tutorials on Electron Devices and Materials

2007 8th Siberian Russian Workshop and Tutorial on Electron Devices and Materials

International Workshops and Tutorials on Electron Devices and Materials

Proceedings. 6th Annual. 2005 International Siberian Workshop and Tutorials on Electron Devices and Materials, 2005.

2004 International Siberian Workshop on Electron Devices and Materials

2003 Siberian Russian Workshop on Electron Devices and Materials. Proceedings. 4th Annual (IEEE Cat. No.03EX664)

Proceedings. 3rd Annual Siberian Russian Workshop on Electron Devices and Materials

IEEE-Siberian Conference on Electron Devices and Materials. SIBEDEM - 2002. Proceedings (Cat. No.02EX529)

2001 Siberian Russian Student Workshop on Electron Devices and Materials. Proceedings 2nd Annual (IEEE Cat. No.01EX469)

Siberian Russian Student Workshops and Tutorials on Electron Devices and Materials (Cat. No.00EX416)

Calculation features of the ultrasonic vibrating systems

Content Provider	IEEE Xplore Digital Library
Author	Khmelev, V.N. Khmelev, S.S. Tsyganok, S.N. Karzakova, K.A. Bobrova, G.A.
Copyright Year	2013
Description	Author affiliation: Center of Ultrasonic Technol., Biysk, Russia (Khmelev, V.N.; Khmelev, S.S.; Tsyganok, S.N.; Karzakova, K.A.; Bobrova, G.A.)
Abstract	The article is devoted to definition of features of development of ultrasonic vibratory systems, which to affect on accuracy of calculation of resonance frequency. Related with threaded connection between parts of vibratory system the feature of calculation is detected. Comparison of result of researches by FEM and parameter of real constructions is made. This comparisons show that at modeling of parts of vibratory system by FEM the core hole in the model must be muted by pin and pin should be taken with a diameter equal to the minimum diameter of the thread.
Starting Page	143
Ending Page	146
File Size	468472
Page Count	4
File Format	PDF
ISBN	9781479907618
ISSN	2325419X
e-ISBN	9781479907625
DOI	10.1109/EDM.2013.6641961
Language	English
Publisher	Institute of Electrical and Electronics Engineers, Inc. (IEEE)
Publisher Date	2013-07-01
Publisher Place	Russia
Access Restriction	Subscribed
Rights Holder	Institute of Electrical and Electronics Engineers, Inc. (IEEE)
Subject Keyword	Acoustics Finite element analysis Junctions Resonant frequency Transducers Joints Frequency measurement engineering calculation Ultrasonic vibrating systems FEM
Content Type	Text
Resource Type	Article

Central Library (ISO-9001:2015 Certified)
Indian Institute of Technology Kharagpur
Kharagpur, West Bengal, India | PIN - 721302

See location in the Map
03222 282435
Mail: support@ndl.gov.in

Sl.	Authority	Responsibilities	Communication Details
1	Ministry of Education (GoI), Department of Higher Education	Sanctioning Authority	https://www.education.gov.in/ict-initiatives
2	Indian Institute of Technology Kharagpur	Host Institute of the Project: The host institute of the project is responsible for providing infrastructure support and hosting the project	https://www.iitkgp.ac.in
3	National Digital Library of India Office, Indian Institute of Technology Kharagpur	The administrative and infrastructural headquarters of the project	Dr. B. Sutradhar bsutra@ndl.gov.in
4	Project PI / Joint PI	Principal Investigator and Joint Principal Investigators of the project	Dr. B. Sutradhar bsutra@ndl.gov.in Prof. Saswat Chakrabarti will be added soon
5	Website/Portal (Helpdesk)	Queries regarding NDLI and its services	support@ndl.gov.in
6	Contents and Copyright Issues	Queries related to content curation and copyright issues	content@ndl.gov.in
7	National Digital Library of India Club (NDLI Club)	Queries related to NDLI Club formation, support, user awareness program, seminar/symposium, collaboration, social media, promotion, and outreach	clubsupport@ndl.gov.in
8	Digital Preservation Centre (DPC)	Assistance with digitizing and archiving copyright-free printed books	dpc@ndl.gov.in
9	IDR Setup or Support	Queries related to establishment and support of Institutional Digital Repository (IDR) and IDR workshops	idr@ndl.gov.in